Page1 of 10 P/N 8007131 Rev. C 1/12/99 BJ ASA Electronics TV/VCP Floor Console Model K-13 Without Harness and Antenna 12 Volt DC powered remote con
Page10 of 10 P/N 8007131 Rev. C 1/12/99 BJ Step 6) Replace the rear shroud and face of console. ⇒ Place the rear and face of the console over th
Page2 of 10 P/N 8007131 Rev. C 1/12/99 BJ This manual contains specific instructions on how to install this automotive TV/VCP floor console. Pleas
Page3 of 10 P/N 8007131 Rev. C 1/12/99 BJ There are six (6) steps to install the K-13 TV/VCP floor console: Step # 1 Disassemble shroud Step # 2 I
Page4 of 10 P/N 8007131 Rev. C 1/12/99 BJ Step #2) Install brackets and straps 1) Mount brackets, using only four screws. Do not use center hole
Page5 of 10 P/N 8007131 Rev. C 1/12/99 BJ 3) Pre-drill pilot holes on side of VCP shelf (A) and on bottom of TV shelf (B) using 1/8” drill bit.
Page6 of 10 P/N 8007131 Rev. C 1/12/99 BJ 4) Attach both straps, use TV and VCP to help locate strap if necessary.
Page7 of 10 P/N 8007131 Rev. C 1/12/99 BJ Step 3) Install console to floor of vehic
Page8 of 10 P/N 8007131 Rev. C 1/12/99 BJ Step 4) Install the VCP into the console. ⇒ Remove the VCP from the box. ⇒ Connect the white RCA co
Page9 of 10 P/N 8007131 Rev. C 1/12/99 BJ Step 5) Install the TV into the console. ⇒ Connect the yellow RCA patch cord (customer supplied) to th
Comments to this Manuals