Audiovox ACAB104 Installation Manual download pdf (Page 5)

Installation Instructions

Before installing this product, take time to familiarize yourself with the items

in the box and use the packing list to verify all parts are present.

Mounting the Sensors

Marking and Drilling Holes

1. Mark the locations of the sensors on the rear bumper using a grease pencil.

a. Identify the sensors height on the bumper and mark. The sensor

height should be between 19.5” and 27.5” from the ground.

b. Mark the location of the left sensor by measuring between 6” to

12”from the left edge of the bumper toward the center. Repeat from

the right edge of the bumper.

c. Determine the center of your bumper and mark. Measuring 12” to 18”

from the center mark, determine the location of the center two sensors

and mark, keeping the four sensors equally spaced (see Figure 1).

d. Inspect behind the bumper where the sensors are to be located to

check for possible obstructions, including metal braces, electrical

wires, and clearance. The sensors need 1” of clearance behind the

bumper to be fully inserted and mounted securely. Do not mount

sensors directly above exhaust pipes. Relocate the sensors if any

obstruction exists.

Equal Spacing of Sensors

6-12"

19.5-27.5"

Figure 1

1 2 3 4 5 6 7 8 9 10 ... 13 14

No comments

Audiovox ACAB104 Installation Manual Page 5