Audiovox Dvd3100 User's Guide download pdf (Page 8)

Programming Your Remote

Auto Code Search

The Auto Code Search searches automatically

through all of the codes stored in this remote. Read

all the following steps prior to starting the auto

search as you will need to be prepared to lock-in

the proper code when found.

1. Manually turn on the device you wish

to control.

2. Press and hold the SETUP button

until the red indicator light stays on

(approximately4seconds)andthen

release the button.

3. Press and release the desired device

button on the remote (TV, DVD, SAT,

AUX). The red indicator will blink

once and then remain on.

4. Point the remote at the device and

press and release the POWER button

(for TV) or PLAY button (for DVD,

VCR, etc.) to start the search. The red

indicatorwillash(approximately

every 2 seconds) as the remote

searches. Note: The remote must be

pointed at the device for the duration

of this search.

5. Placeyourngeronthe#1 button so

you are prepared to lock-in the code.

6. Whenthedeviceshutsofforbegins

playing, press the #1 button to lock-in

the code. The red indicator light will

turn off. Note: You have

approximately two seconds after the

device shuts off or begins playing to

lock-in the code.

7. Point the remote at the device and

check to see if the remote operates

the device as desired. If it does, no

further programming is required for

that device. If it does not, return to

step 2 and start the auto search.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Audiovox Dvd3100 User's Guide Page 8