Audiovox 5BLCR User Manual

Browse online or download User Manual for For the car Audiovox 5BLCR. Audiovox 5BLCR User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
128-6690
1 of 8
Model 5BLCR &
5BLCRA
Programming Guide
The 5BLCR is designed to work with most Audiovox two way remote start unit
and may be programmed differently for other models. For the APS-55TW, the
recommended transceiver programming is shown below.
Note: A total of 4 transmitters may be programmed into any receiver channel.
1 Lock
2 Unlock
3 Remote Start/Stop
4 Option
The 5BLCRA is designed to work with most Audiovox two way alarm sys-
tems and may be programmed differently for other models. For the APS-590,
the recommended transceiver programming is shown below.
1 Lock
2 Unlock
3 Trunk Release (Optional)
4 Option
The intent of the Option button is to facilitate operation of other Audiovox RF
devices such as a second vehicle or a Garage Door Interface unit.
In the case of the APS-590, there is also an additional output on the control
module in the vehicle which may be programmed to operate from the Opt.
Button. Please check with your installation center for the programming of your
unit.
A total of 4 transmitters may be programmed into any receiver channel.
Force programming a transmitter, removing a transmitter, or reprioritizing a
transmitter is covered later in this manual.
Also, if you do not program a transmitter button into channel 2 which is the
separate unlock/disarm channel, then whatever button is programmed into
channel 1 will serve as both lock/arm & unlock/disarm.
Note: The “F” Button serves as a function button in combination with other
buttons explained in your owners manual. This button may not be used to
operate a receiver channel.
Note: Alarm units have a sounding device, siren or horn, keyless entry units
may or may not include a sounding device. Where mentioned, you may or may
not hear a chirp from the siren or horn. In the case of a keyless entry unit,
when entering a code, the unit will flash the parking lights to indicate the code
is learned.
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Model 5BLCR &

128-66901 of 8Model 5BLCR &5BLCRAProgramming GuideThe 5BLCR is designed to work with most Audiovox two way remote start unitand may be programmed

Page 2 - 128-6690

128-66902 of 8As mentioned above, the program mode refers to a Keyless Entry unit whichhas no sounding device, you will note mention of a long chirp f

Page 3

128-66903 of 8NOTE: If the program switch is operated again, the circuit will recyclethrough the program mode. In other words, press 1 time to acces

Page 4

128-66904 of 82 Enter the transmitter program mode. Using any transmitter button pressand hold until a long chirp is heard. If a single chirp or mu

Page 5

128-66905 of 83. Remove the discharged battery, making note of the location of the + and -contacts shown, and replace with a new type alkaline 1.5 vol

Page 6

128-66906 of 8Attention: Transmitter Ordering DepartmentImportant: To help us expedite your order, please print all of the informationlegibly and mai

Page 7

128-66907 of 8THIS PAGE LEFT BLANK INTENTIONALLY7

Page 8

128-66908 of 8128-6690© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 117888

Comments to this Manuals

No comments