Audiovox Platinum APS 675 User Manual

Model APS 675Installation Manual3 Channel Remote Start / Keyless Entry SystemInstallation InstructionsThis Unit Is Intended For Installation In Vehicl

Typically this output will be used to re-lock the vehicle doors if the doors unlock automatically when theignition circuit transitions to off.Black w/

Dark Blue/Black and Green/White - 2 Pin Input/Output Harness:Dark Blue/Black Trace Wire: External Trigger InputThe Dark Blue/Black trace wire allows t

To program these selectable features:1. Start with the programming switch in the OFF position.2. Turn the ignition key to the ON position.3. Flip the

TIMED START PROGRAM:The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature isuseful in extremely co

To test the integrity of this circuit:1. With the driver's window in the down position, start the vehicle using the RF transmitter.2. Reach insid

MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:Mechanical neutral safety switch configurations differ slightly in that they do not offer the same lev

Additional information concerning Key In Sensor methods1&2arelisted below and should be reviewedbefore considering either alternative.Method 1 wil

METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key

WIRING DIAGRAM182nd White© 1998 Audiovox Corp., Hauppauge, N.Y. 11788 Form No. 128-5367

The APS-675 Remote Start/Keyless Entry System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a selectable ignition

3allowed for the body of the switch, and also that the drill will not penetrate any existing factory wiring or fluid lines.Drill a 1/4" hole in t

used ) and the neutral safety switch as shown in the following diagram.Failure to connect this wire to the ignition switch side of the of the neutral

WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a soli

Brake Switch Positive Shutdown DetailYELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE

The Light Blue wire can be used to accommodate the following situations:A. Shock Sensor By Pass:If there is Shock Sensor used with an alarm system and

DARK GREEN/ORANGE Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote Startmodu

3 Wire Positive Switched Door Locks:In this application, the Red wire of the two pin harness providesa+12volt pulse during the disarmingsequence, or p