Audiovox APS 686T User Manual

128-72011 of 20Model APS 686TInstallation Manual4 Channel Remote Start / Keyless Entry SystemInstallation InstructionsThis Unit Is Intended For Instal

128-720110 of 203 Wire Positive Switched 2 Step Door LocksThe green wire provides a positive pulse during locking, or the pulsed + 12 volt lock output

128-720111 of 203 Wire Positive Switched Door Locks:In this application, the Red wire of the door lock harness provides a + 12 volt pulse during the

128-720112 of 20Black w/ Yellow Trace Wire: Ground Output During Start (Crank)The Black w/ Yellow Trace wire will provide a 300 mA ground output whil

128-720113 of 203 Pin Input/Output Harness:Dark Blue/Black Trace Wire: External Trigger InputThe Dark Blue/Black trace wire allows the remote start un

128-720114 of 20NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and becertain to connect the tach inp

128-720115 of 20TIMED START PROGRAM:The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature isusefu

128-720116 of 201. With the driver's window in the down position, start the vehicle using the RF transmitter.2. Reach inside the car and pull the

128-720117 of 20CAUTION!REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILYDISCONNECTED IN STEP 3DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL

128-720118 of 20KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there aretwo alter

128-720119 of 2019METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin

128-72012 of 20This Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only! Theunit provides a selectable

128-720120 of 20© 2004 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-7201

128-72013 of 20Drill a 1/4" hole in the desired location and mount the switch by passing it through the panel from the under-side. Secure the sw

128-72014 of 20NOTE: This wire must be connected to the vehicle side of the starter cut relay (if present). For the electricalneutral switch configur

128-72015 of 20WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground sour

128-72016 of 20BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starte

128-72017 of 20GREEN/YELLOW Wire: Diesel Wait To StartFor Diesel glow plug preheat circuits, this wait to start input will allow the ignition to keep

128-72018 of 204. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to terminal #87a of therelay. Connect the other side

128-72019 of 203 Wire Ground Switched 2 Step Door LocksIn this application, the red wire provides a ground pulse during locking, or the pulsed ground