Audiovox Automobile Alarm PRO 9233 User Manual download pdf

128-7777

1 of 8

Congratulations on your purchase of the PRO9233 automotive Keyless Entry

Upgrade Alarm System. This system is a state - of - the - art auto security system

that is designed to automatically arm and disarm when it receives a command from

your existing Factory Keyless Entry Transmitter. Taking a few moments to read this

manual will help to ensure that your vehicle is protected at all times.

NOTE:

The system has the ability to beep the vehicle's horn, sound a siren, or both. Where

a beep or chirp is mentioned, consider either or both may sound.

ARMING THE SYSTEM : ( ACTIVE )

1. Turn the ignition key off, exit the vehicle, and close all doors.

2. Press and release the Lock button on the keychain transmitter.

3. The siren and or horn will beep one time, the parking lamps will flash one time,

and the red dash mounted LED will begin to slowly flash, indicating that the

system is ARMED.

If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.

Simply close the opened entry point to provide full protection. If the siren "chirped"

three times, sometime after arming, the exclusive delayed dome light learn circuit

has been programmed and the system detected a open entry point after the

learned delay expired. Again, closing the hood, trunk, or doors will correct the

problem and you do not need to disarm the system to make the correction. If the

siren/horn did not sound when arming, then the chirps have been turned off, and

you should refer to the section titled “ ELIMINATING THE ARM / DISARM CHIRPS “

in this manual.

4. Any time the door lock switch in the vehicle is used to lock the doors while

the ignition key is turned off, the system will immediately arm. To lock the doors

after entering the vehicle, make sure the ignition key is switched on first.

Turning the ignition key on first will stop the system from arming.

ARMING THE SYSTEM : ( PASSIVE )

1. Turn the ignition key off, exit the vehicle, and close all doors.

2. The dash mounted LED will begin to flash rapidly, indicating that the system

Model PRO 9233

OWNER’S MANUAL

KEYLESS ENTRY ALARM UPGRADE MODULE

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Model PRO 9233

128-77771 of 81Congratulations on your purchase of the PRO9233 automotive Keyless EntryUpgrade Alarm System. This system is a state - of - the - art a

Page 2 - 128-7777

128-77772 of 82is automatically ( passively ) arming. As an added convenience, the 30 secondautomatic passive arming will not begin until all doors ar

Page 3

128-77773 of 83installed, the vehicle’s interior lights will turn on for 30 seconds, or until theignition key is turned on.NOTE: If your system has be

Page 4

128-77774 of 84TO ENTER THE VALET MODE:1. Disarm the unit by use of the factory transmitter or by use of the manual overridesequence.2. Turn the ignit

Page 5

128-77775 of 85the manual override sequence. If the code is not successfully entered within thethree attempts, disarming with the manual override swi

Page 6

128-77776 of 86Custom Code Programming Example:To Change the code from the factory pre-assigned code of 11 to “52” you would dothe following:1. Disarm

Page 7

128-77777 of 87To operate the optional accessory;1. Press the lock, then unlock, then lock buttons on your keychain transmitter within3 seconds.2. The

Page 8 - PRO 9233

128-77778 of 88PRO 9233SYSTEM FUNCTIONS AT A GLANCEPASSIVE ARMINGARMEDDISARMEDVALET MODEINTRUSION ZONE 3INTRUSION ZONE 2INTRUSION ZONE 1ARMDISARM