Audiovox APS-620 User Manual download pdf

128-7829

1 of 12

Model APS-620

Installation Manual

This Remote Start System is designed to be used with

Automatic Transmission- Fuel Injection Vehicles Only!

COMPONENTS:

Control Module

2 Four Button RF Transmitters

Antenna/Receiver

1 1” X 1.75” Foam Pad

6 Pin Main Power Harness

7 Pin Accessory Harness

1 Hood Pin Switch

1/4” Female Spade Connector

2 Pin Door Lock/Unlock Harness

3 Pin Parking Light/Ground Harness

2 Pin LED Assembly

2 Pin Push-Button Valet/Program Switch

3 Pin Antenna Receiver Harness

4 Pin Auxiliary Output Harness

4 Philips Head Black Drill Point Sheet

Metal Screw #8 X 1/2"

Installation/Owners Guide

FEATURES:

-Selectable Ignition Lock & Unlock

-Selectable Door Lock/Unlock Output Timing

-Safe Start (Requires double push of the start button to engage the remote start

function)

-On-Board Parking Light Relay

-Trunk Release Output

-Horn Chirp Output With Selectable Duration

-Selectable RF Start Chirp

-Car Finder Mode (Can elect to have horn beep along with parking lights if

connected)

-Selectable Run Times 5, 10, 15, or 20 Minutes

-Selectable Gas or Diesel

-Automatic Start Timer (Can be set to start your car automatically at 2 or 4 hour

intervals)

-4 Negative Pulsed Aux Outputs Before Start, After Start, During Crank, After

Shutdown (To aid installation in many vehicles with factory alarm systems)

FCC NOTICE

This device complies with part 15 of the FCC rules. Operation of this device is subject to the

following conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

Caution: Changes or modifications not expressly approved by the party responsible for

compliance voids the users authority to operate this device.

1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - Model APS-620

1128-78291 of 12Model APS-620Installation ManualThis Remote Start System is designed to be used withAutomatic Transmission- Fuel Injection Vehicles O

Page 2

10128-782910 of 12Setting Up The System Programming Features:Bank 1 Transmitter ChannelsStart with the system disarmed, turn the ignition switch to th

Page 3

11128-782911 of 12COMPLETING THE INSTALLATION:After you have confirmed the operation of the Audiovox Remote Start unit and tested all thesafety featur

Page 4

Page 5

2128-78292 of 12INSTALLATION OF THE MAJOR COMPONENTS:CONTROL MODULE:Select a mounting location inside the passenger compartment (up behind the dashboa

Page 6

3128-78293 of 12DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MULTI PIN INPUT /OUTPUT HARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS TOTHE

Page 7

4128-78294 of 12the circuit and select the correct installation method. In addition you will realizewhy the connection of the safety wire is requi

Page 8

5128-78295 of 12

Page 9

6128-78296 of 12Wiring The 4 Pin Auxiliary Output Harness, Connector “A”The auxiliary 4 pin connector provides low current outputs to control various

Page 10 - 10 of 12

7128-78297 of 123 Pin Antenna/Receiver, Connector “F”Route the 3 pin connector from the previously installed antenna receiver assemble to themating co

Page 11 - 11 of 12

8128-78298 of 12VEHICLE TO THE CONSUMER IF THIS CIRCUIT DOES NOT PERFORM AS SPECI-FIED.Green w/ Orange Trace Wire: Tachometer Input SignalThis wire wi

Page 12 - 12 of 12

9128-78299 of 12A. Shock Sensor By Pass:B. Additional Ignition Output:C. GM VATS Key Override:Green w/ White trace Wire: Entry Illumination Ground Ou