128-77701 of 20The selectable features can be set manually as explained below, or with the RF feature programmer.To set features using the RF programm
128-777010 of 20A. Shock Sensor By Pass:If there is Shock Sensor used with an alarm system and it is not shunted during the Remote Start activation pe
128-777011 of 20Tachometer Input Wiring Detail11Green/Yellow Wire: Diesel Wait To Start InputThe Green/Yellow wire of the 2 pin connector will connect
128-777012 of 20The Red & Green Door Lock/Unlock output wires provide either a pulsed ground or pulsed + 12 volts to control thevehicle door lock
128-777013 of 2013nience, the AS 9159a Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the Audiovoxfax back service for
128-777014 of 2014cylinder, four coil systems, connect to any of the three coils.3. Connect the Yellow wire to a +12 volt ignition 1 source. This wi
128-777015 of 201. Set the vehicle parking brake.2. Block the drive wheels to prevent vehicle movement.3. Temporarily disconnect the Brown/Black pos
128-777016 of 20KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alte
128-777017 of 20METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin sw
128-777018 of 20COMPLETING THE INSTALLATION:After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety feature
128-777019 of 20© 2006 Audiovox Electronics Corp., Hauppauge, NY 11788 128-7770
128-77702 of 20To program these selectable features;Action System ResponseTurn ignition on No responsePress and release the valet switch 3 times 1 Ch
128-77703 of 20To exit program mode, turn ignition off, or press and release valet switch.RF Programmable Features Bank 3 Is Remote Start Selectable F
128-77704 of 20Action System ResponseTurn ignition on No responsePress and release the valet switch 3 times 1 Chirp - LED 1 flashWithin 3 seconds, tu
128-77705 of 20This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! Theunit provides wait to start i
128-77706 of 206THE RECEIVER/ANTENNA ASSEMBLY:The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dash
128-77707 of 20NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutralswitch configura
128-77708 of 20VIOLET WIRE: Accessory OutputConnect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the
128-77709 of 20Brake Switch Positive Shutdown DetailYELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: You must disconnect the igni
Comments to this Manuals