Audiovox HDP100 - Acoustic Research HD Powerlink User's Guide download pdf (Page 10)

ot h e r Se t u p op t I o n S



Make sure both units are plugged directly into unswitched, non-GFI outlets. Do not

plug them into a surge protector.

The units may be too far from each other. Try moving them to outlets that are closer

together.





Make sure your TV is on.

Make sure your TV is switched to the correct input for the HDP100.

If you’re using an HDMI switcher or AV receiver, make sure it’s turned on and

switched to a source outputting a signal.

Check the HDMI connection between the receiver and your TV. Make sure both ends

are rmly connected.

Check the output mode of your signal source: the HDP100 supports 480p, 720p, and

1080p resolutions. Check the owner’s manual that came with your signal source

device to nd out how to set its output mode.

Try a different HDMI cable.

Reset and re-link the units (the procedure is illustrated on the next page).



Turn the HDP100 receiver off, then back on again.





Turn the HDP100 receiver off, then back on again.

Make sure the display or AV receiver are not muted.





Check the output mode of the signal source. If it’s set to 1080p, switch it to 720p.

The units may be too far from each other. Try moving them to outlets that are closer

together

1 2 ... 5 6 7 8 9 10 11 12

No comments

Audiovox HDP100 - Acoustic Research HD Powerlink User's Guide Page 10