Audiovox VOH701 - VOH 701 - LCD Monitor Owner's Manual download pdf (Page 16)

• Before connecting to the SPEAKERS

terminal

A speaker cord is actuall3, a pair of insulated cables

running side by side. Cables are coh)red or shaped

dilt)mntly, perhaps with a stripe, groove or ridges.

Connect the striped (grooved. etc.) cable to the "+" (red)

terminals of this unit and your speaker. Connect the plain

cable to lhe "" (black) terminals.

Remove approximately 10 mm (3/8") of insulation

from the end of each speaker cable and then

twist the bare wires of the cable together to

prevent short circuits.

Connecting to the SPEAKER terminals

nooat,vo,-,

;,:#,,,,vo<+,

1 Loosen the knob.

2 Insert the bare end of the speaker wire into

the hole on the terminal.

3 Tighten the knob to secure the wire.

Connecting the banana plug

(except Europe, Russia, Korea, and Asia models)

The banana plug is a single-pole electrical connector

widely used to terminate speaker cables. First, tighten the

knob and then insert the banana plug connector into the

end of the corresponding terminah

Banana plug

12 En

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 105 106

No comments

Audiovox VOH701 - VOH 701 - LCD Monitor Owner's Manual Page 16