Audiovox VME 9309TS Owner's Manual download pdf (Page 32)

Subject to technical changes

MONTAGE

1. INSTALLATION

Remove the four screws that attach the mounting sleeve to the radio and remove the sleeve.

2. Install the half-sleeve.

a. Install adapter if necessary (optional).

b. Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow.

c. Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard

opening, bend as many of the tabs outward as necessary so that the sleeve is firmly secured to the dashboard.

d. Install support strap to make the unit more stable.

CAUTION! Be careful not to damage the car wiring.

3. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve.

Wiring

Complete wiring as illustrated in the wiring diagram on page 8. Once the wiring is complete, reconnect the battery negative terminal. If there is no ACC

available, connect the ACC lead to the power supply with a switch.

NOTE:

When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The VME 9309TSB uses one 15 amp mini-ATM fuse, lo-

cated in the black filter box in-line with the main wire harness.

Final Installation

After completing the wiring connections, turn the unit on to confirm operation (ignition switch must be on). If unit does not operate, recheck all wiring until

problem is corrected. Once proper operation is achieved, turn off the ignition switch and proceed with final mounting of the chassis.

1. Connect wiring adapter to existing wiring harness.

2. Connect antenna lead.

3. Carefully slide the radio into the half-sleeve, making sure it is right-side-up, until it is fully seated and the spring clips lock it into place.

1 ... 31 32 33 ... 84

Comments to this Manuals

No comments

Audiovox VME 9309TS Owner's Manual Page 32

Comments to this Manuals