Audiovox CTV-5040 Technical Information download pdf (Page 11)

Connections & Setup

What you will need:

Two (2) RF coaxial cables

• Two (2) A/V cables

One (1) S-Video cable

• One (1) telephone line cord

• Coaxial cable lines fed from a digital satellite antenna and a standard TV antenna (or cable line)

Making the Connection

1. Connect the satellite dish antenna feed (RG-6 coaxial cable) to the SATELLITEIN jack on the satellite

receiver.

2. Connect one end of an RF coaxial cable to the OUT TO TV jack on the satellite receiver, and the other end

to the antenna input jack on the VCR.

Note: If your VCR has AN input jacks, you can use A/V cablesto connect the satellite receiver's second

AN jacksto the AN jacksof the VCRinstead of usingthe RFcoaxialcable.

3. Connect one end of an RF coaxial cable to the antenna output jack on the VCR, and the other end to the

TV's antenna input jack.

4. Connect the cable or off-air antenna feed (RF coaxial cable) to the IN FROM ANT jack on the satellite

receiver.

5. Connect one end of the supplied telephone line cord to the PHONE JACK on the back of the satellite

receiver, and the other end to an RJ11-type modular phone jack (the most common type of phone jack).

6. Connect two ends of the supplied A/V cables to AUDIO R and L jacks on the satellite receiver, and the

other ends to the corresponding audio input jacks on the TV.

Note: Make sure you connect jacks by their labels. For example, AUDIO R on the digital satellite receiver

should be connected to TV's right audio input jack, L Audio to L Audio, etc.

If your TV only has one audio input jack, use the satellite receiver's AUDIO L jack to make the

connection.

7. Connect one end of the supplied S-Video cable to the satellite receiver, and the other end to the

S-Video input jack on the TV.

Go to Page 15

Using Your Components

To watch DIRECTV* programming:

Tune the TV to its S-Video line input (if you have difficuhy finding your TV's S-Video line input, see your

TV's User'sManualor page 66 in this manual). Then tune the satellite receiver to the desired channel.

To record DIRECTV* programming:

Tune the satellite receiver to the desired channel. Then set your VCR to record on the proper input

channel (video line input if using A/V cables to connect the VCR to the satellite receiver, channel 3 or 4 if

using RF coaxial cable).

To view VCR recordings:

Tune the TV to channel 3 or 4 (whichever is set on the VCR as its output channel). Begin VCR pktyhack

as usual.

Chapter 1 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 79 80

No comments

Audiovox CTV-5040 Technical Information Page 11