Audiovox CTV-5040 Technical Information download pdf (Page 27)

Using the Remote Control

Component

buttons and

ON,OFF

button

PLAY

REVERSE

button

STOP

button

LED

Programming the Remote Control

The digital satellite receiver's r(*nlote carl be progr_Elnlned to control I]IOSt

brands of remote controllable components. The remote is already programmed

to control lnost RCA, OR and Proscan components: it may need to he

programmed to control other manufacturers' brands.

Testing the Remote Control

To determine whether the universal remote control needs to be programmed,

turn a component on, such as a VCR, point the remote at the VCR, and press

the VCR button. Then press ON-OFF or CH + or CH - to see if the VCR

responds to the remote commands. If not, the remote needs to be programmed.

There are two ways to program the remote control: Automatic Code Search or

Direct Entry.

Using Automatic Code Search

The following instructions can be used to program the remote to control many

of the components connected to your TV. If you want to exit the automatic

code search without programming any of your components, press the CLEAR

button until the LED (red light) turns off.

Turn on the component you want to control (VCR, satellite receiver, etc.)

Press and hold the button you want to program. While holding the

component button, press and hold ON*OFF until the LED on the remote

control turns on, then release both buttons.

Note: The AUX button can only be programmed using direct code entry. See

"Using Direct Entry," later in this section, for details.

Point the remote at the component, press and release PLAY, then wait five

seconds or until the LED stops flashing.

At this point the remote control is searching for tile correct code to program.

If, after five seconds, the component you want to control does not turn off,

press and release PLAY again to tell the remote to search tt_e next set of

codes.

Continue pressing and releasing PLAY until the component turns off or you

have searched through all of the codes. There are 20 total sets of codes. If

tile compnnent does not turn off after pressing PI.AY 20 times, then the

remote cannot c<)ntrol that particular conlpol3Cllt,

If the component yon v, ant to control d(_('s ltl/'[1 O{'1:

1. Press and rdease REVERSE, then wait txxo seconds. Repeat this step until the

component turns back on.

2. TO finish, press and hold ST()I_ until the LEI) on the rcmot,: control turns

ofh

Chapter 2 25

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 79 80

Comments to this Manuals

No comments

Audiovox CTV-5040 Technical Information Page 27

Comments to this Manuals

Related products and manuals for TV set-top boxes Audiovox CTV-5040