Audiovox CTV-5040 Technical Information download pdf (Page 19)

Connections & Setup

Place Batteries in the Remote

Control

Follow these steps whenever you need to install or change the batteries in your

digital satellite receiver's remote control.

Note: When replacing old batteries, you may need to reprogram the remote

control to operate other devices.

1. Remove the cover from the battery compartment.

2. Insert batteries in the battery compartment, matching the + and - end of

each battery.

3. Replace the cover.

Plug in and Turn On the Receiver

Plug the end of the power cord into the wall outlet. Be sure to insert the plug

completely.

To turn on the satellite receiver, press the SAT button on the remote control or

the ON*OFF button on the front panel. If your TV brand is RCA, GE, or

Proscan, press the TV button on the remote control to turn on the TV. If your

TV brand is not RCA, GE, or Proscan, see page 25 in the next section, Using the

Remote Control, for details on programming the satellite receiver's remote

control to operate your TV.

Locating the VCR's Infrared

Remote Control Sensor

The VCR Controller must be affixed directly over the infrared remote control

sensor on your VCR.

Some VCRs have a label that identifies the remote control sensor, but others do

not. If the IR sensor is labeled on your VCR, affix the VCR Controller directly

over the sensor. For VCRs that do not label the sensor, you can use the VCR's

remote control to locate the VCR's sensor before affixing the VCR Controller

cable.

To Find the VCR's Remote Control Sensor:

1. Hold the VCR's remote ccmm_l so that it is touching the tront of the VCR.

2. Slowly move the remote control over the front of the VCR while repeatedly

pressing the remote control's power button.

3. When your VCR turns on/off, you have locateci tile remote control sensor.

Note: To test the VCR controller's position, use a piece of vinyl tape to

temporarily attach the VCR controller to the spot where you think the sensor

is located. Then see Selecting a VCR Type on page 19 to see if the VCR

Controller is positioned correctly.

Chapter 1 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

No comments

Audiovox CTV-5040 Technical Information Page 19