Audiovox LF30S Datasheet download pdf (Page 7)

Controls and Features

The transmitter and receiver units look virtually alike but are

labeled accordinly on the front of the units. However, the receiver

can also be identified by the threaded RF coax connector labeled

“TO TV” on the back panel.

A - Directional 2.4GHz antenna (both units)

Sends and receives A/V signals.

Caution: Do not attempt to rotate the antenna a full 360 degrees,

or permanent damage to the antenna and mechanical stopper

will occur.

B - Channel Selection Switch (both units – underneath unit)

Both the transmitter and the receiver must be set to the same

channel for proper operation.

C - On/Off Switch (both units)

Turns the transmitter and receiver on or off.

D - 15V DC Power Port (both units)

Both adapters are the same and are interchangable.

E - Audio/Video Jacks (both units)

Right and left stereo audio (red/white) jacks and a composite

(yellow) video jack are used for connection to A/V components

and/or TV sets.

F - RF Connector (receiver only)

Used to connect the RF output from the receiver unit to the RF

input of a TV set.

G - Channel 3/4 Video Selector Switch (receiver only –

underneath unit)

Set the output of the receiver unit to either channel 3 or 4, to

correspond to the TV channel you wish to watch the A/V source

video on.

H - IR Extender Jack (transmitter only)

Allows you to remotely control the A/V source that is

connected to the transmitter.

I - Antenna (both units)

Sends and r

eives remote control signals.

LF-30S

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

No comments

Audiovox LF30S Datasheet Page 7