Audiovox Dvd3100 User's Guide download pdf (Page 11)

11

2. Press and release the device button

(TV, DVD, SAT, AUX) which is

programmed to control the Master

Volume Feature.

3. Press and release the

MUTE button.

4. Press and release the VOL -

button. The red indicator light

will blink twice and go off.

To make sure the Master Volume

Feature is disabled, put the remote in

TV mode if you programmed the audio

receiver to be the Master Volume

Device. Point the remote at the TV and

press a volume button. If the volume

changes on the TV, the feature is

disabled. If the volume on the audio

receiver changes, and not the TV, you

will have to repeat the steps above

and test again.

Reset to Factory Settings

1. Press and hold the SETUP button

until the red indicator stays on

(approximately4seconds)andthen

release the button.

2. Press and release the OK button.

3. Press and release the number #0

button. The red indicator light will

ashtwice.

Master Volume Feature, cont.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments