Audiovox MMD11A Installation Guide download pdf (Page 6)

VEHICLE PREPARATION:

1) Locate an accessory power source (+12v when key is in the ACC. and run positions,

and 0v when key is off), and also a good ground generally, these wires can be found at

the ignition switch or fuse-box.

2) The mounting method and location will vary from vehicle to vehicle, so this manual will

only focus on the installation of the MMD11 and related console accessories.

3) Generally, the best location for the video monitor is where the vehicle's factory dome

light is installed. The monitor should be located in such a manner that it can be

comfortably viewed by rear seat passengers.

NEVER INSTALL THE MONITOR IN A PLACE WITHIN THE DRIVER'S VIEW. THIS IS

NOT ONLY DANGEROUS, BUT IT IS ALSO ILLEGAL IN MANY STATES.

4) Once the mounting location of the monitor has been determined, there may be

additional preparation work necessary, depending on the vehicle structure and

installation method. Some of the steps that may be required are:

A) Removal of the vehicle's dome light

B) If the trim ring will be used, it may have to be trimmed to fit the contour of the

vehicle's headliner. Refer to the "Trim Ring Installation" section in this manual.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Audiovox MMD11A Installation Guide Page 6