Audiovox MMD11A Installation Guide download pdf (Page 8)

MOUNTING THE TRIM RING

Roof

Roof Support

Headliner

Mounting Bracket

Self-drilling Screws

Trim Ring

Video Unit

M5 Screw

MMD11

1) Make the connections to the vehicle for the 12 pin wiring harness.

2) Connect power harness to vehicle’s electrical system by tapping into an accessory hot

line and a good ground.

3) Connect the 12 pin harness to the mating connector on the Video Monitor.

4) Verify all functions of the System before final mounting of the finished assembly.

A/V Source Definitions:

1. DVD – Built in DVD

2. AV1 – Supplied 9 Pin to 3 RCA Jack Pigtail is used for VIDEO 1 input.

3. AUX – AUX

*NOTE: If the optional relay box P/N SIRSWB is installed, it recommended that the

antenna for the wireless FM Modulator be unplugged. See MMD11 Wiring

Diagram (Figure A) for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM

Modulator to exceed FCC limits for wireless transmission. When installing the

unit position the antenna for best reception.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Audiovox MMD11A Installation Guide Page 8