Audiovox PR-140 Service Manual download pdf (Page 32)

Connecting the IR<Blaster

The cable box is controlled via the DVD recorder with the IR-Blaster

(supplied). This means you can record TV shows that are received only

through the cable box.

Connection of the G-LINK™ cable enables the TV Guide On

Screen

™

system to show the correct guide listing.

1 Connect the IR Blaster to thejack G-LINK jack on the back of the

DVD recorder.

2 Place the IR Blaster in front of the cable box so that the control

signal (IR signal) can be transmitted and received by the cable box

without interference.

How do I find the right position?

If the position of the remote (IR) receiver is indicated on your cable box

(IR, remote sensor, or such like), place the transmitter about 1 inch in

front of it.

If the position is not indicated, proceed as follows:

- Switch off the cable box.

- Point the remote control at the front of the cable box.

- Move the remote control slowly along the front while repeatedly

pressing the on/off button.

- When the cable box switches on you've found the receiver.

- Attach the IR blaster about one inch away.

3 Confirm the displayed information with OK .

Setting up the cable box

For the cable box to be correctly identified it must be connected as

described in the previous section.

1 Switch the cable box on and select channel number 02 on it.

2 Select your type/brand from the list shown. If you scroll down with

B , you will see further brands. If your type/brand is not in the

list, select 'not listed'.

3 Confirm with OK . Read the information on the screen carefully.

4 Confirm with OK .

P The DVD Recorder will now attempt to use the G-LINK

connection to select channel number 09 on the cable box.

5 Has the cable box been switched to channel 09?

If so, select 'Yes'.

If not, select 'No'.

a My cable box has not switched to the other channel

number.

- Check that the cable box is connected and switched on.

- Check the connection and position of the IR blaster.

- If the connection is OK, select:

'test this code again' for a new attempt.

- Confirm with OK on the remote control.

- For a new code, select 'No'.

- Confirm with OK on the remote control.

a My cable box is not displaying the channel number.

- On your TV set, select the channel number of the cable box and check

the setting on the screen of the TV.

Finalize set<up

1 Check the settings shown on the screen. If the settings are not

correct, repeat the set-up procedure with the selection of 'No,

repeat setup process'. Otherwise, select 'Yes, end setup

process'.

2 Confirm with OK .

You will now see a screen with useful information of the TV Guide

On Screen

™

System.

3 Confirm with OK .

You will now see a message confirming the completion of the TV

Guide On Screen

™

set-up process.

4 Confirm with OK . This completes the set-up process for the TV

Guide On Screen

™

system.

5 Switch the DVD-Recorder off with the STANDBY m button. If

you have connected a cable box leave the box on. Leave the

DVD-Recorder and the cable box in this conditions overnight.

The data will be collected and will be available within the next 24

hours.

If the DVD-Recorder is switched off ( STANDBY m button) the cable

box will be used from the TV Guide On Screen

™

system via the

DVD-Recorder to search for the informations.

If you want to use the cable box you have to switch the DVD-Recoder

on.

The TV Guide On Screen ™ System

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 89 90

Comments to this Manuals

No comments

Audiovox PR-140 Service Manual Page 32

Comments to this Manuals

Related products and manuals for DVD players Audiovox PR-140