Audiovox PR-140 Service Manual download pdf (Page 83)

PROBLEM SOLUTION

A DVD+RW disc

cannot be played on

certain DVD players

bIf a recording is too short, it is possible that a DVD player cannot detect it: Please observe the following

'Minimum recording times':

Recording mode 'M1': 5 minutes, 'M2': 10 minutes, 'M2x': 13 minutes, 'M3': 15 minutes, 'M4': 20 minutes,

'M6': 30 minutes, 'M8': 30minutes,

bSome DVD players cannot play back DVD+RW recordings. You can solve this problem by using a special

function:

1 Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.

2 Hold down the number button 2 on the remote control until the tray closes. The disc is

modified.

3 You can restore the disc to its original condition by pressing 1 .

Warning!

There is a risk that you can no longer play the disc on other DVD players after this procedure.

Therefore, apply this function with particular care.

Other disc errors

(DVD+RW)

bIf it is impossible to play back a disc, you can try and repair it for new recordings using the following function.

This will only prepare the disc for erasing. It will not be erased, however, until the recording has been

completed.

1 Clean the disc

2 Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.

3 Hold down the red function button on the remote control until the tray closes. The disc is

prepared for erasing.

4 Start recording as with an empty disc.

Other disc errors

(DVD+R), 'Disc

contains unknown

data' interruption of a

recording (power

outage)

bThis message may appear if you instert a DVD+R that was not finalized or an error occurs during the

recording. DVD+R's that have not been finalized are very sensitive to fingerprints, dust, or dirt. This may

cause problems during recording.

To use the disc again, follow the next steps

1 Make sure that the surface of the disc is clean.

2 Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but do not close

the tray.

3 Hold down 5 on the remote control until the tray closes. The disc will be read ('READING'

appears on the display) and the DVD recorder will start the repair process. This may take up

to four times as much time as the recording, in which the error occurred.

4 If the disc is recovered, the index screen will appear.

Please observe the following:

The recovering procedure is successfully only if there was a previous recording on the disc.

Error during recording: The title may be missing.

Error while changing the title/index picture: The original title/index picture may be visible.

Error while finalizing: The disc appears not to have been finalized.

The index screen

flickers when a DVD+R

is inserted

bYou can finalize the disc using the following function:

1 Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but do not close

the tray.

2 Hold down 4 on the remote control until the tray closes.

'FINALIZING' appears in the display. Finalizing begins. This may take up to three minutes.

3 If finalizing has been successful, the index screen will appear.

ENGLISH

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89 90

Comments to this Manuals

No comments

Audiovox PR-140 Service Manual Page 83

Comments to this Manuals

Related products and manuals for DVD players Audiovox PR-140