Audiovox PR-140 Service Manual download pdf (Page 80)

If you have any problems using this DVD recorder, the reason may be one of the following. You can

also call the customer service centre in your country.

You can also visit our web page 'http://www.p4c.philips.com' .

Have the model number (MODEL NO) and the production number (PROD.NO) of your recorder

ready.

The production number (PROD. NO.) is printed on the type plate at the back or on the bottom

PROBLEM SOLUTION

Your recorder does

not respond to any

button being pressed

and the display shows

'PHILIPS', 'IS TV ON?':

bRecorder in initial installation mode: Switch on the TV, switch over to the DVD recorder jack or if you have

only connected the DVD recorder to an antenna cable select channel 3 or 4 on the TV.

Now the menu for language selection should appear. Please read paragraph 'Initial Installation' in the chapter

'Installing your DVD Recorder'.

The device does not

react when you press a

button, although the

remote control works:

b'Dealer-Mode' is switched on: All buttons on the front of the set are locked.

Switch off the function:

1 Pull out the AC-outlet plug from the AC- outlet.

2 Press and hold down h and OPEN/CLOSE J and put back the AC-outlet plug into the

AC- outlet.

3 As soon as the time or '--:--' appears in the display (ca. 6 - 10 seconds), release h and

OPEN/CLOSE J .

Your DVD recorder

does not respond to

any button being

pressed:

bThere is no power supply: check the power supply

bThere is a technical problem: disconnect from the AC-outlet for 30 seconds, then connect again.

If this doesn't help, you can reset your DVD recorder to the default factory settings.

Resetting the machine

to the default factory

settings

bImportant:

All the information stored (TV channels, time and date, TIMER) will be lost.

1 Disconnect from the AC-outlet.

2 Press and hold down the STANDBY-ON m button on the device and reconnect to the

AC-outlet.

3 Release the STANDBY-ON m button when the features appears on the display. All the

information stored (TV channels, time and date, TIMER) will be lost.

Please read paragraph 'Initial Installation' in the chapter 'Installing your DVD Recorder'.

Remote control does

not work:

bRemote control not pointed toward the DVD recorder: Point the remote control at the machine. See if the

'o(((' appears on the display briefly each time you press a remote control button. If it does, the Recorder is

receiving information from the remote correctly.

bThere is a technical problem: Take out the batteries, wait for 10 seconds and put them in again.

bBatteries are flat: Change the batteries.

I can not switch off the

DVD<Recorder:

bA recording is in progress (red light around the REC/OTR n button is switched on). After the recording is

finished, the DVD-recorder will switch off automatically.

Fans run with switched

off DVD recorder:

bFor the execution of certain procedures the DVD recorder can switch itself on automatically, although no

information is visible on the display. To prevent overheating, the fans at the back will be switched on and off

automatically

This is no fault of your set.

Before you call an engineer

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 89 90

Comments to this Manuals

No comments

Audiovox PR-140 Service Manual Page 80

Comments to this Manuals

Related products and manuals for DVD players Audiovox PR-140