Audiovox Platinum APS 675 User Manual download pdf (Page 6)

Brake Switch Positive Shutdown Detail

YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass Output

NOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE ALARM FROM ANY OTHER WIRE

THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.

This wire providesa+12Volt output when the ignition key is turned to the “ON” position, and 0 Volts when

the ignition key is “OFF” and when the vehicle is running under the control of the remote starter.

This wire should be connected to the ignition input of the alarm system.

The Yellow w/ Black wire output will allow you to remote start the vehicle while leaving the alarm armed, and

to lock/unlock the doors while running under control of the remote start unit.

(2) WHITE Wires: Parking Light Flasher

These wires are the COMMON and NORMALLY OPEN contacts of the on-board parking lamp relay.

If the vehicle's parking lights are a +12 volt switched system, connect (1) of the White wires to a fused (15A

max.) +12 volt battery source, and connect the second White wire to the vehicle's parking light wire.

If the vehicle's parking lights are a chassis ground switched system, connect (1) of the White wires to a chassis

ground source, and connect the second White wire to the vehicle's parking light wire.

LIGHT BLUE Wire: Ignition 3 / Shock Disable Output

This wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit

initializes, and remains grounded while running plus an additional 4 seconds after the Remote Start Unit

turns off. In all of the applications described below, a relay will be required.

White or White w/ Red

Trace WireFrom Remote

Start Module

WhiteFromRemote

Start Module

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Audiovox Platinum APS 675 User Manual Page 6