Audiovox PSS100 - Standard Rear Only System Installation Manual download pdf (Page 10)

Mounting the Control Module

Determine a dry place inside the vehicle (out of the way) to mount the control

module (e.g., behind an inner body panel), making sure that all wiring will

reach the intended location.

1. Plug the sensor wires, speaker and power harness into the control

module before mounting. The sensor must be plugged into the

corresponding socket (see Figure 4). The control module is pre-fitted

with Velcro for mounting.

2. Clean the pre-selected mounting area to ensure good adhesion.

3. When the surface is dry, peel the backing off the Velcro pad and

attach the control module.

LS – Left Side Sensor (only used in 4 sensor install)

RS – Right Side Sensor (only used on a 4 sensor install)

Figure 4

1 2 ... 5 6 7 8 9 10 11 12 13

No comments

Audiovox PSS100 - Standard Rear Only System Installation Manual Page 10