Audiovox PSS100 - Standard Rear Only System Installation Manual download pdf (Page 9)

Mounting the Speaker

The speaker has three volume settings: Off, Hi, and Low. Since the speaker

can be adjusted as needed, you should mount the speaker in an accessible

location in the interior. Speaker should be visible by driver, allowing them to

see the LED indicators.

1. Route the wires for the speaker to the area where you will install the

control module. Make sure they will not be pinched by the panel or

moving parts.

2. Clean the back of the speaker and the mounting location to ensure

good adhesion. When the location is dry, peel the backing strip off the

Velcro tape and place on the back of the speaker. Next, peel the

backing strip off the other side of the Velcro tape and press on the

cleaned surface. Use the optional mounting screws (provided), if

necessary.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Audiovox PSS100 - Standard Rear Only System Installation Manual Page 9