Audiovox AA-RS10CS Installation Manual

Browse online or download Installation Manual for Motor vehicle electronics Audiovox AA-RS10CS. Audiovox AA-RS10CS Installation manual User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
128-5850A
1 of 16
Kit Contents
AA-RS10CS Control Module
(2) - 3 Button Anti Code Grabbing Transmitters
3 Channel Code Learning Receiver
External Superheterodyne Antenna/Receiver
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Auxiliary Harness
(1) - Two Pin I/O Harness
(1) - Accessory 2 Pin Connector
(1) - 2 Pin Door Lock Harness
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch
(1) - Programming Switch
(1) - Ring Terminal
(4) - 1/2" Long Screws
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
Model AA-RS10CS
Installation Manual
3 Channel Remote Start / Keyless Entry System
Installation Instructions
This Unit is Intended for Installation in Vehicles with 12 Volt Negative Ground
Electrical Systems, Gasoline Tach Reference and Automatic Transmissions Only.
Released 1-23-02.
Released 7-10-00.
Page view 0
1 2 3 4 5 6 ... 15 16

Summary of Contents

Page 1 - Installation Instructions

128-5850A1 of 16Kit Contents AA-RS10CS Control Module(2) - 3 Button Anti Code Grabbing Transmitters3 Channel Code Learning ReceiverExternal Superhete

Page 2

128-5850A10 of 16Page 10Feature Selection 1 Flash 2 Flashes DefaultFirst 1 Second Door Locks 3.5 Second Door Locks 1 SecondSecond 10 Minute Run Time 1

Page 3

128-5850A11 of 16Page 11The AA-RS10CS Remote Car Starter will learn the tach rate of most vehicle's ignition coils, multiple coil packs, and orsi

Page 4

128-5850A12 of 16Page 12HOOD PIN SAFETY SHUT DOWN:The intention of the hood pin safety shut down is to prevent the Remote Start unit from being activa

Page 5

128-5850A13 of 16Page 13MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:Mechanical neutral safety switch configurations differ slightly in that they d

Page 6

128-5850A14 of 16Page 14not alert the owner that the key has been left in the ignition switch. In addition, this may also effect other warning toness

Page 7

128-5850A15 of 16Page 15To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin sw

Page 8

128-5850A16 of 16WIRING DIAGRAM© 2000 Audiovox Electronics Corp., Hauppauge, NY 11788 128-5850A

Page 9

128-5850A2 of 16The AA-RS10CS Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only!The unit provides a s

Page 10 - 10 of 16

128-5850A3 of 16Page 3WIRING THE 6 PIN MAIN POWER HARNESS:RED w/ WHITE Trace Wire: + 12 volt Battery 1 SourceConnect this wire to a + 12 VDC constant

Page 11 - 11 of 16

128-5850A4 of 16Page 4BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts w

Page 12 - 12 of 16

128-5850A5 of 16Page 5GREY Wire: Negative Inhibit Input 1Connect the GREY wire to the previously mounted hood pin switch provided . This wire will be

Page 13 - 13 of 16

128-5850A6 of 16Page 6(2) WHITE Wires: Parking Light FlasherThese wires are the COMMON and NORMALLY OPEN contacts of the on-board parking lamp relay.I

Page 14 - 14 of 16

128-5850A7 of 16Page 74. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to terminal #87a of the relay.Connect the othe

Page 15 - 15 of 16

128-5850A8 of 16Page 8In this application, the Red wire of the two pin harness provides a ground pulse during the arming sequence, or pulsedground loc

Page 16 - WIRING DIAGRAM

128-5850A9 of 16Page 9Audiovox AS-9159 Door Lock Interface, (or equivalent 30 A automotive relays) must be used. Refer to the AudiovoxDoor Lock Wirin

Comments to this Manuals

No comments