Audiovox AA-RS10CS Installation Manual download pdf (Page 4)

128-5850A

4 of 16

Page 4

BLUE Wire: Ignition 1 Output

Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignition key is

turned to the to the "ON" or "RUN" and the "START" or CRANK" positions, and will have 0 volts when the key is turned

to the "OFF" and "ACCESSORY" positions.

For Diesel Applications, this wire must be connected to the ignition circuit that powers the glow plugs if the vehicle

requires glow plug pre-heating. (See selectable feature #9)

GREEN Wire: Ignition 2 Output

Connect this wire to the ignition 2 wire from the ignition switch. This wire will show + 12 volts when the ignition key is

turned to the "ON" or "RUN" position and is some cases the "START" or CRANK" position. This wire will show 0 volts

when the key is turned to the "OFF" and "ACCESSORY" positions.

NOTE: See programming information concerning this wire to allow output during the "START" mode.

VIOLET Wire: Accessory Output

Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignition switch

is turned to the "ACCESSORY" or "ON" and "RUN" positions, and will show 0 volts when the key is turned to the "OFF"

and "START" or "CRANK" positions.

WIRING CONNECTIONS: 12 Pin Input / Output Harness

Black Wire: Chassis Ground Source

Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain to

remove any paint or grease and secure this wire with a self taping screw and ring terminal.

BLACK w/WHITE Tracer Wire: Control Switch

The Black w/ White tracer wire provides ON-OFF control of the Remote Starter.

When the Black w/ White wire is switched to a full time ground, the AA-RS10CS Remote Start Module is operative. When

the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled.

Connect the Black w/ White tracer wire to one of the wires from the back of the previously mounted control switch. Connect

the remaining wire of the control switch to chassis ground. Always try to mount the switch so that the ON position is in

an upward or toward the driver direction.

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Audiovox AA-RS10CS Installation Manual Page 4