Audiovox ACC-40 Operations Instructions download pdf (Page 41)

2-21

SECTION 2

DRIVING YOUR MOTOR HOME

they can have on the roof awning. It is a good

idea to retract the room any time high wind con-

ditions would also make it necessary to roll in the

patio side awning. This will protect the slide-out

room awning from possible wind damage.

If Slideout Room Will Not Operate

(Troubleshooting)

• The chassis battery may be low on charge.

Press the Aux. Start switch on the dash to the

momentary (MOM) position while pressing

the slide-out control switch. This momentari-

ly connects the coach batteries to assist in

retracting the room.

• One of the fuses may be blown. Fuses are

located on the interior firewall beneath the

dash, beneath the instrument panel dash pod,

and inside the leveling control pad housing.

• If the batteries and fuses are okay, there may

be a failure in the hydraulic system or electri-

cal system. See “Emergency Crank-In In-

structions” below for help.

Slideout Galley Emergency Crank-In

Procedure (Use only when galley slideout will

not retract using control switch)

If a failure occurs in the slideout electrical or

hydraulic systems, and the room will not retract

using the control switch, you can manually crank

the room in using an emergency winch system

described below. The winch is stored in a cargo

compartment on the passenger side of the coach.

Step 1 - Relieve Hydraulic Line Pressure

• Open the hydraulic pump valves to release

hydraulic line pressure and let fluid bypass

into the fluid reservoir. The pump is located

in the LP tank compartment on the driver side

of the vehicle.

• Open the 2 T-handle valves on the FRONT

END of the pump only. Turn T-handles

counter-clockwise to open.

DO NOT OPEN ANY OF THE 4 VALVES

ON THE BACK END OF THE PUMP be-

cause they regulate the leveling jacks.

NOTE: The T-handles may turn easily at first but

will become more difficult to turn as

internal springs are compressed. Be sure

to open both valves completely (about 6

turns of each T-handle).

Step 2 - Attach Winch and Crank Room

Inward

• Remove the register from the floor heat duct

and anchor the winch in the floor. Insert the

winch retainer bracket into the duct cutout in

the floor as shown.

WARNING

Stop engine, place transmission in

park position and apply parking brake

before lying beneath vehicle for this

procedure.

Slideout Pump in

LP Tank Compartment

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 123 124

Comments to this Manuals

No comments