Audiovox ACC-40 Operations Instructions download pdf (Page 95)

8-11

SECTION 8

APPLIANCES & INTERIOR FEATURES

LP GAS FURNACE

(SUBURBAN)

To Start Up:

1. Close the LP gas tank valve.

2. Turn thermostat/system switch on. (Refer to

Electronic Thermostat instructions.)

3. Set thermostat above room temperature to

begin blower operation. A slight delay will

occur before the blower comes on. Allow

blower to run for 5 minutes for combustion

chamber purge cycle.

4. After 5 minutes, set thermostat lever below

room temperature. Blower will remain on.

Wait approximately 2 minutes for blower to

go off.

5. Open LP gas tank valve.

6. Set thermostat to desired temperature. If set

above room temperature, blower will come

on.

7. Allow 30 seconds for main burner to light

after blower comes on. This furnace is

equipped with an ignition device which auto-

matically lights the burner. Do not try to light

the burner by hand.

8. If burner does not light, repeat Steps 1

through 5. (If heat does not come out of the

heat duct after a minute or so, the burner is

not lit.)

9. If after three (3) attempts with no ignition, go

to shut-down and contact your dealer or a

local recreational vehicle service center. Do

not continue to cycle furnace through ther-

mostat in an attempt to get ignition.

NOTE: For normal operation after initial start-

up, be sure the thermostat switch is in

HEAT position, then place the tempera-

ture selector to the desired temperature.

The furnace will start and cycle on and

off automatically.

To Shut Down:

1. Slide thermostat/system switch OFF.

2. Close LP tank valve.

For Further Information

Please see the Suburban furnace operating

instructions provided in your Owner’s InfoCase

for further information, including operating pre-

cautions, and periodic maintenance.

ELECTRONIC THERMOSTAT

(Central Heat/Air Conditioning System Only)

The thermostat, located in the galley area,

controls heating, air conditioning and cooling fan

features.

NOTE: The thermostat does not automatically

switch between heating and cooling. You

must place the switch in the desired posi-

tion.

Heating:

• Slide the system switch up to “Heat” posi-

tion.

NOTE: Follow proper furnace lighting proce-

dures described previously in this sec-

tion.

Heating/Cooling

Thermostat

Power Ventilator

Thermostat

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 123 124

Comments to this Manuals

No comments

Audiovox ACC-40 Operations Instructions Page 95

Comments to this Manuals

Related products and manuals for Cars Audiovox ACC-40