2-23
SECTION 2
DRIVING YOUR MOTOR HOME
Bedroom Slideout
Emergency “Push-In” Procedure
• Open the two hydraulic line valves on the
front side of the pump to relieve hydraulic
line pressure. (See Step 1 under “Slideout
Room Emergency Crank-In” on previous
pages.)
• DO NOT OPEN THE FOUR VALVES ON
THE REAR SIDE OF THE PUMP. These
regulate the coach leveling jacks.
• Apply a steady inward pressure of approxi-
mately 150 lbs. to the exterior sidewall of the
slideout room to push the room in toward the
coach until it is snug against the main coach
sidewall.
• NOTE: Use some type of rigid, padded mate-
rial to protect the sidewall from punctures,
dents or other damage to the finish from any
device or equipment used to press the side-
wall in.
• Pressure must be applied evenly to avoid
binding of the hydraulic mechanism. It may
take about 10 minutes to press the room ex-
tension inward completely.
• When the room is snug against the coach
wall, close the hydraulic line valves to pre-
vent “creep out” during transit.
• See an authorized Winnebago Industries
dealer for service of the slideout control sys-
tem.
Further Information
See the HWH Hydraulic Room Extension
operating guide included in your Owner’s Info-
Case for further instructions and troubleshooting
information.
Comments to this Manuals