Audiovox ONYX User Manual download pdf (Page 17)

32 33

•Sedan/Coupe With Antenna Placed at the Front of the Roof:

1. Feed the antenna cable from the antenna underneath the rubber

molding around the windshield. Use a blunt plastic putty knife or

similar blunt tool to lift the rubber molding around the windshield

and tuck the antenna cable underneath the molding. Route the

antenna cable around and down the windshield to the lowest point.

2. At the lowest corner of the windshield, route the cable out of the

windshield molding and into the rubber weather stripping around

the door opening. Lift the weather stripping from the opening and

tuck the cable inside it,

then replace the weather

stripping. Run the cable

inside of the weather

stripping to the bottom of

the door opening.

3. Pull the cable out of the

weather stripping at

the bottom of the door

opening and route it under the carpet toward the dashboard. Coil

any excess cable in a hidden location, such as under the carpet,

keeping it away from any vehicle pedals or controls. Secure the

excess cable with wire ties.

4. Bring the end of the cable out at the PowerConnect Vehicle Dock

location. Leave yourself enough cable so you can easily connect it

to the antenna connector of the dock.

Vehicle Installation

5. Continue with “Step 5: Connect the Magnetic Mount Antenna

and PowerConnect Power Adapter” on page 37.

•SUV:

1. Feed the antenna cable underneath the rubber weather

stripping of the rear tailgate window/door and route the cable

along the rear hatch. Lift the weather stripping from the

opening and tuck the cable inside it, then replace the weather

stripping. Pull the cable out from weather stripping and route

it into the cabin under the interior trim. Avoid hinges or gears

that could crimp or cut the cable.

2. Route the cable through the SUV’s main cabin area under

the interior trim, towards the front of the vehicle. Use a blunt

plastic putty knife or similar blunt tool to lift the plastic trim

just enough to tuck the cable under underneath. Avoid side

airbag locations

on back pillars and

above the doors.

Airbag locations are

marked with “SRS”

logos. Be careful not

to crimp or cut the

cable.

3. Bring the cable out

from the trim near

the front of the cabin

and route it under

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Comments to this Manuals

No comments

Audiovox ONYX User Manual Page 17

Comments to this Manuals

Related products and manuals for Radio Audiovox ONYX