Audiovox ONYX User Manual download pdf (Page 18)

34 35

the carpet toward the dashboard or console. Coil any excess cable

in a hidden location, such as under the carpet, keeping it away from

any vehicle pedals or controls. Secure the excess cable with wire ties

(purchased separately).

4. Bring the end of the cable out at the PowerConnect Vehicle Dock

location. Leave yourself enough cable so you can easily connect it to

the antenna connector of the dock.

5. Continue with “Step 5: Connect the Magnetic Mount Antenna and

PowerConnect Power Adapter” on page 37.

•Convertible:

1. Bring the antenna cable from the antenna into the trunk at the front

edge of the trunk lid. Keep any bends in the cable loose. Tape or tie the

cable along the inside of the trunk lid to the trunk lid hinge strut.

2. Allow enough slack in the cable so the trunk lid can easily open and

close and keep the cable away from hinges, gears, etc., that could

crimp or cut it. Route the cable

along the trunk wall and into the

cabin through a conduit or along

an existing wiring harness.

3. Route the cable through the main

cabin area under the interior trim,

towards the front of the vehicle.

Use a blunt plastic putty knife or

similar blunt tool to lift the plastic

trim just enough to tuck the cable

Vehicle Installation

under underneath. Avoid side airbag locations on back pillars

and above the doors. Airbag locations are marked with “SRS”

logos. Be careful not to crimp or cut the cable.

4. Bring the cable out from the trim near the front of the cabin

and route it under the carpet toward the dashboard or console.

Coil any excess cable in a hidden location, such as under the

carpet, keeping it away from any vehicle pedals or controls.

Secure the excess cable with wire ties (purchased separately).

5. Bring the end of the cable out at the PowerConnect Vehicle

Dock location. Leave yourself enough cable so you can easily

connect it to the antenna connector of the dock.

6. Continue with “Step 5: Connect the Magnetic Mount Antenna

and PowerConnect Power Adapter” on page 37 .

•Pickup Truck:

1. Use a blunt plastic putty knife

or similar blunt tool to lift

the rubber molding around

the windshield and tuck the

antenna cable underneath it.

2. Continue tucking the cable

underneath the windshield

molding around the windshield

to the lowest corner.

3. At the lowest corner of the

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Comments to this Manuals

No comments

Audiovox ONYX User Manual Page 18

Comments to this Manuals

Related products and manuals for Radio Audiovox ONYX