Audiovox ACC-40 Operations Instructions download pdf (Page 97)

8-13

SECTION 8

APPLIANCES & INTERIOR FEATURES

flow for the air conditioner to operate ef-

ficiently.

Condenser Coils

The condenser is located in a compartment

on the left side of the coach. The condenser is

the large, silver, rectangular area that looks like a

car radiator.

Periodically sweep debris carefully from the

fins of the condenser. Rinse dust off with clean

water. The condenser coils must be clean and

free of dust, debris and insect particles, etc., for

the air conditioner to cool efficiently.

Further Information

See the air conditioner manufacturer’s operat-

ing instructions supplied in your Owner’s Info-

Case. They contain detailed operating

instructions, special precautions and basic trou-

bleshooting.

TV ANTENNA

The TV antenna on your motor home can be

easily raised, rotated a full 360° and lowered

from inside the vehicle by simply turning a crank

or rotating knob. A built-in signal amplifier de-

signed to strengthen signals, is controlled by a

power switch built into the TV jack assembly.

The signal amplifier is housed inside the an-

tenna with the circuit board connected directly to

the antenna elements. Power to operate the am-

plifier (12-volt DC) is supplied through the

downlead cable which also carries the TV signals

to the TV set. The power supply separates the 12-

volt DC from the TV signals and provides a place

for attaching the TV set and the 12-volt power

source.

Operation

Raising Antenna - Turn elevating crank

clockwise in “UP” direction about 13 turns or un-

til some resistance to turning is noted. Antenna is

now in operating position. Turn amplifier power

switch “ON” to receive TV signal.

Rotating Antenna - Make sure antenna is in

the “UP” position. Pull down on rotating knob

until it disengages ceiling plate and rotate for best

picture and sound on TV set.

Lowering Antenna to Travel Position - Ro-

tate antenna until pointer on rotating knob aligns

with pointer on ceiling plate.

Turn elevating crank (counterclockwise) in

“DOWN” direction until resistance is noted. An-

tenna is now locked in travel position. Turn am-

plifier power switch “OFF”.

Count the number of turns needed to crank the

antenna down to the roof of the unit (normally

WARNING

Never allow the antenna to touch

electrical power lines or any other

electrical wires.

CAUTION

Never leave the antenna partially

raised or partially lowered. This can

damage the crank mechanism gears.

Always raise the antenna straight up

or lower it completely into the travel

position.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 123 124

Comments to this Manuals

No comments

Audiovox ACC-40 Operations Instructions Page 97

Comments to this Manuals

Related products and manuals for Cars Audiovox ACC-40