Audiovox AOM-713WP Specifications download pdf (Page 112)

Proposal Number PSDF #P09-0004

BATTERY BANK

A single battery system shall be provided, utilizing four (4) high cycle type Group 31 batteries.

This system shall be capable of engine start after sustaining a continuous 150 amp load for 10 minutes with

the engine off (NFPA-1901).

A battery disconnect switch (Rated at not less than 450 amps continuous) shall be used to activate the system

and provide power to the power panel. A green pilot light shall illuminate to indicate that the1 battery bank

is activated.

BATTERY CABLES

All battery wiring shall be "GXL" battery cable capable of handling 125% of the actual load. It shall be run

through a heat resistant flexible nylon "HTZL" loom rated at a minimum of 300 degrees Fahrenheit. All

cable connections shall be machine crimped and soldered.

STARTING CIRCUIT

One (1) engine start button is to be located on the lower right dash panel. It shall be wired to heavy duty

solenoid rated at not less than 1100 amps. The battery indicator light is to be located directly above the start

button to indicate that the battery bank is on.

BATTERY CONDITIONER / CHARGER

A KUSSMAUL AUTO CHARGE 1200 battery charger shall be installed, under the driver's seat, for

charging the batteries. This charger shall include an integral bar graph display to indicate the condition of

the batteries. Automatic sensing of the battery condition shall stop charging when the batteries are fully

charged.

Specifications:

Input: 115 volts 50/60 Hz. 12 amps maximum

Output: 12 vdc 0-40 amps

SHORELINE AUTO-EJECT

A KUSSMAUL Super Auto Eject, model 091-55-20-120, with yellow weatherproof cover shall be mounted

on the cab exterior immediately adjacent to the rear of the driver's door.

The Super Auto Eject is to be completely sealed to prevent internal contamination of the working

components.

The internal switch arrangement of the Super Auto Eject shall be designed to close and open the 120-volt AC

circuit after the mating connector is inserted and before the connector is removed. This design shall prevent

arcing at the connector contacts to provide long life.

The electrical connection shall be provided as a 120-volt AC - 20 amp type using a NEMA 5-20P connector.

Page 112

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 170 171

No comments

Audiovox AOM-713WP Specifications Page 112