Audiovox ONYX User Manual download pdf (Page 10)

18 19

Vehicle Installation

Installing the Vent Mount:

1 Locate a vent with horizontal

louvers sturdy enough to hold your

PowerConnect Vehicle Dock and radio.

2 If the vent louvers in your vehicle

are recessed, you may need to use

the longer vent clamps with the Vent

Mount. If so, remove the shorter vent

clamps and install the longer ones

into the Vent Mount. Be sure to observe the orientation of the vent

clamps as shown.

3 Push the Vent Mount onto the vehicle vent as shown (1) until it

hooks on the rear of the vent louver (2).

4 Rest the foot against the bottom of the vent (2), and adjust the

tilt of the Vent Mount by repositioning the foot to a different

adjustment hole (3).

To remove the Vent Mount, push the mount into the vent. Then lift up until

disengaged from the rear of the vent louver, and remove the Vent Mount.

PUSH

Dash

Vent

Louver

Foot

Vent

Dash

HOOKED

TILT

ADJUSTMENT

HOLES

1 2 3

Slide Short Vent Clamps Out

Remove End Cap

Slide Extended Vent Clamps In Replace End Cap

Extended Vent Clamps

Short Vent

Clamps

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

No comments

Audiovox ONYX User Manual Page 10