Audiovox APS-997C Installation Manual download pdf (Page 17)

128-8775b

17 of 32

4 Black w/ Yellow Trace Wire: Ground Output During Start (Crank)

The Black w/ Yellow Trace wire will provide a 300 mA ground output while the starter output of the remote

start unit is active. This output can be used to activate the Crank Low/Bulb Test wire found in some GM

vehicles. This wire is also referred to as the ECM wake up wire in some vehicles.

NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement

is more than 300 mA.

2 Pin Transponder Control Output: (Yellow Connector) Part # 1122392

a: When selected for while remote start on, the Black wire will be active at the same time ign. 3 be-

comes active, and will remain active all the time the unit is operational under the control of the remote

start.

b: When selected for output during the start sequence, the Black wire will be active at the same time Ign.

3 becomes active, and will remain active until the vehicle has started. This will be used for one time read

transponder circuits.

c: When the unit is selected for until ignition off, the Black wire will become active at the same time ign.

3 becomes active and will remain active even after the key take over and until the ignition in the vehicle is

turned off. This will allow the unit to be used for continuous read transponders circuits.

1 Black: 250mA Output (-)

The black wire switches on when the remote start is activated and will stay on as programmed in the

remote start feature Bank3 Feature 12.

2 Red: 250mA Output (+) 12 Volts Constant

This output is intended to allow the control of a transponder bypass interface module or transponder

bypass relay.

Additional Harnesses And Connectors For The System

4 Pin Upgrade Telematic Module: (Connector Port)

Red = + 5 Volts / Black = Ground / White = Data TX / Yellow = Data RX

Connect the 4 pin harness found in the Telematic one way or CArlink II kits to the mating port on the

controlling circuit.

NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the + 12

volt supply for the two way module must be sourced separately or the unit will not operate.

6 Wire Antenna/Receiver Program Push-Button Switch/LED Connector: Part # 1123908

Plug the previously routed antenna connector from the antenna receiver assemble into the mating connector

of the control module. This connector supplies 12 volts, ground and RF data input and output, LED cathode,

and Valet Enable to and from the antenna receiver and the remote start module. Be certain this connector

is firmly seated making good contact to the control unit.

4 Pin Shock Sensor: (White Connector) Part # 1122591

The Red (+12 volt), Black (ground), Blue (pre-detect) and Green (full trigger when armed) wires loaded into

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Audiovox APS-997C Installation Manual Page 17