Audiovox APS-997C Installation Manual download pdf (Page 26)

128-8775b

26 of 32

The transmitters are pre-programmed from the factory, If you find you need to program new or additional

transmitters follow the instructions below.

PROGRAMMING BANK 1 (TRANSMITTERS):

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps).

3 Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or

siren.

4) Turn the ignition switch off.

The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons of the system. For additional

channel programming see the owners guide found within the literature bag packaged with this kit.

PROGRAMMING BANK 2 (ALARM FEATURES):

You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1.

(Siren Short then Long Chirp), or You can also go right to bank 2 by:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times. (Siren Chirps)

3) Turn the ignition key off then on. (Siren Short Then long Chirp)

4) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use the

lock button of the transmitter to select the feature setting.

Example to set passive arming:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times. (Siren Chirps)

3) Turn the ignition key off then on. (Siren Short Then long Chirp)

4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button

of the transmitter to select two chirps "Passive Arm".

5) To exit the programming mode, turn the ignition key off. The program mode is automatically exited when

there is no activity on the pushbutton switch or the transmitter lock button.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Audiovox APS-997C Installation Manual Page 26