Audiovox APS-997C Installation Manual download pdf (Page 28)

128-8775b

28 of 32

PROGRAMMING BANK 3 (REMOTE START ):

You can enter Bank 3 from Bank 2 by turning the ignition key off then on after you've made the changes you

wanted in Bank 2, (Siren two Long Chirp), You can also go right to bank 3 by:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps).

3) Turn the ignition key off then on. (Siren Short Then long Chirp)

4) Turn the ignition key off then on. (Siren two Long Chirp)

5) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use

the lock button of the transmitter to select the feature setting.

Example to set engine input check to DBI Tach:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps).

3) Turn the ignition key off then on. (Siren Short Then long Chirp)

4) Turn the ignition key off then on. (Siren two Long Chirp)

5) Press the pushbutton switch five times to advance to features 5, Input Check, then use the lock button of

the transmitter to select three chirps, "DBI Tach"

6) To exit the programming mode, turn the ignition key off. The program mode is automatically exited when

there is no activity on the pushbutton switch or the transmitter lock button.

TACH RATE PROGRAMMING:

1. Turn the ignition key to the On position.

2. Press and release the valet/program push button switch 3 times.

3. Immediately turn the ignition key Off.

4. Press and hold the valet/program push button switch, then start the vehicle using the key.

5. When the unit senses the tach signal, the parking lights will begin to flash.

6. Release the valet/program pushbutton switch. The parking lights will turn on for three seconds to indicate

that the learned tach signal is stored and the unit is out of the tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach source, the

parking lights will not flash. To correct this situation, locate and connect the Green/Orange wire to the

proper tach signal, and then repeat the tach learn routine.

1 2 ... 23 24 25 26 27 28 29 30 31 32

No comments

Audiovox APS-997C Installation Manual Page 28