Audiovox CTV-5040 Technical Information download pdf (Page 28)

Using the Remote Control

Using Direct Entry

1. Turn on the component to be programmed.

2. Look up the brand and code number(s) for the component on the code list at the end of this

section.

3. On your remote control, press and hold the component button you want to program.

4. While pressing the component button, enter a code from the code list.

5. Release the component button, and then press ON-OFF to see if the component responds to

the remote control commands. If it doesn't, try pressing the component button and then

ON • OFF again.

6. If you get no response, repeat these steps using the next code listed for your brand, until the

component responds to tile remote control commands.

One Button Recording

If your remote is programmed to

operate a VCR, and the VCR is

properly connected to the satellite

receiver, you only need to press

the RECORD button to begin

recording from video.

Operating Other Components

Once the remote has been programmed successfully, you are ready to use it to

operate your components.

To Operate the Component:

1. Press the component button (TV, VCR1, SAT, VCR2, or A[PX) to set the

remote to control the component.

2. Press ON-OFF to turn the component on or off.

3. Use the remote control buttons that apply to that component.

Modes of Operation

Because this universal remote can control several diflerent components (DVD

player, VCR, cable box, etc.) it uses operational modes triggered by the

component buttons. For example, if you want the remote control to operate the

TV, press the TV button to put the remote into TV mode. If you want to play a

videotape, press VCR1 then PLAY (pointing the remote at the VCR).

Controlling a Second Satellite Receiver

The remote can control two satellite recei\,el-s, l_'roln [tic, Mail] ill{,nl.[, select

System Setup then System Options, then R_,mote .S>tlq_.Then l}_llo\'_ the on-

screen instructions and enter the appropriate code from the Satellite Receiver

list at the end of this section. By default, the SAT button is tt_,ec]to control the

first satellite receiver and the AI.JX button is usec] u) tonHoJ the se_o0d satellite

receiver.

If your second receiver is an RCA, GE. or Ploscan :rod 3_nl want to _ontt-o[ it

using the AUX button, use code 5001. Code -_0()0is used ])V the SAT bulton.

26 Chapter 2

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Comments to this Manuals

No comments

Audiovox CTV-5040 Technical Information Page 28

Comments to this Manuals

Related products and manuals for TV set-top boxes Audiovox CTV-5040