Audiovox D2016 - DVD Player - 10.2 Instruction Manual download pdf (Page 9)

Before Using the TX-SR502/TX-SR502E

The Worldwide model has a voltage selector for compat-

ibility with power systems around the world. Before you

plug in this model, make sure that the voltage selector is

set to the correct voltage for your area. If it isn’t, use a

small screwdriver to set it as appropriate. For example, if

the voltage in your area is 120 volts, set the selector to

“120V.” If it’s between 220 and 230 volts, set it to “220-

230V.”

Notes:

• The batteries should last for about six months,

although this will vary with usage.

• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent damage from

leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

To use the remote controller, point it at the TX-SR502/

TX-SR502E’s remote control sensor, as shown below.

Notes:

• The remote controller may not work reliably if the

TX-SR502/TX-SR502E is subjected to bright light,

such as direct sunlight or inverter-type ﬂuorescent

lights. Keep this in mind when installing.

• If another remote controller of the same type is used in

the same room, or the TX-SR502/TX-SR502E is

installed close to equipment that uses infrared rays,

the remote controller may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-

ently, thereby draining the batteries.

• The remote controller may not work reliably if the

TX-SR502/TX-SR502E is installed in a rack behind

colored glass doors. Keep this in mind when install-

ing.

• The remote controller will not work if there’s an obsta-

cle between it and the TX-SR502/TX-SR502E’s

remote control sensor.

Setting the Voltage Selector

(Worldwide model only)

Installing the Batteries

To open the battery compartment, press

the small hollow and slide off the cover.

Insert the two supplied batteries (AA/R6)

in accordance with the polarity diagram

inside the battery compartment.

Put the cover onto the remote controller

and slide it shut.

ANTENNA

120

VOLTAGE

SELECTOR

220

230

SWITCHED

100W MAX.

AC OUTLET

AV RECEIVER

MODEL NO. TX

502

OPTICAL COAXIAL

123

DIGITAL

VIDEO 1

/2/3IN

SURROUND

SPEAKERS

CENTER

SPEAKER

SURROUND BACK

SPEAKER

REMOTE

CONTROL

FRONT

SURR CENTER

SUB

WOOFER

OUT

VIDEO 2

VIDEO 1

DVD MONITOR

OUT

VIDEO

S VIDEO

DVD

TAPE

VIDEO 2

VIDEO 1

SUBWOOFER

PRE OUT

DVD

COMPONENT VIDEO

OUT

FRONT

SPEAKERS A

FRONT

SPEAKERS B

Class 2 Wiring

120

VOLTAGE

SELECTOR

220

230

Using the Remote Controller

30˚

TX-SR502/

TX-SR502E

Approx. 16 ft.

(5 m)

Remote control sensor

STANDBY indicator

TX-SR502_En.book Page 9 Tuesday, February 17, 2004 12:14 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Comments to this Manuals

No comments

Audiovox D2016 - DVD Player - 10.2 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for AV receivers Audiovox D2016 - DVD Player - 10.2