Audiovox AFX-35.00 Installation Manual download pdf (Page 10)

128-8971a

10 of 32

compartment and connect to the negative side of the ignition coil. This Remote Start unit learns the tach rate

of the vehicle and in most cases will operate properly from one multi coil pack regardless of the number of

cylinders. If the vehicle has a single coil unit for each cylinder, it may be necessary to connect this wire to

more than one cylinder for proper tach reference. See Multi Coil Pack Adaptor wiring detail shown later in

this manual for additional information.

NOTE: For Hybrid mode selection, Bank 3 feature selection 5, this connection is not required, the unit will

start the vehicle and run the allotted time based on feature selection and crank duration.

9 Orange Wire: 300mA (-) Ground When Armed Output

This wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibit

relay. Connect the Orange wire to terminal #86 (orange wire) of the relay provided. Connect terminal #85

(red wire) of the relay to an ignition wire in the vehicle that is +12 Volts when the ignition switch is turned

to the on and start positions and off when the key is off. Locate and cut the low current start solenoid

wire found at the vehicles ignition switch harness. This wire will have + 12 Volts when the ignition key is

moved to the start (crank) position and will have 0 Volts in all other key positions. Connect one side of

the cut wire to terminal #87a ( Black wire) of the relay. Connect the other side of the cut wire to terminal

#30 (White/Black wire) of the relay. See below for detail of wiring, also see Yellow Start wire detail for

connection to vehicle considerations.

10 Brown w/ Black Trace Wire: Positive Inhibit Input Plus Trigger When Armed

The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever

it gets + 12 Volts also triggers the alarm when armed. If the Brake lights switch in the vehicle switches + 12

Volts to the brake light circuit, connect the Brown w/ Black trace wire to the output side of the brake switch.

This will allow the Remote Start to shut down if an attempt is made to operate the vehicle without the key

while running under the control of the Remote Start. In most vehicles, in order to shift into gear, the brake

pedal must be depressed. The brake input will in turn cause the remote start unit to shut off.

11 Black Wire: Chassis Ground Source

Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be

certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal.

12 Brown Wire: (-) Negative Door Trigger

If the vehicle's door courtesy light switches ground when the door is opened, (Most GMs and imports), you

must connect this wire to the negative output from one of the vehicle's door pin switches. In most cases the

Brown wire will need to be connected to only one door switch no matter how many doors the vehicle has as

most door lighting circuits are wired in parallel. This wire will be shunted when remote starting the vehicle

and will remain shunted, if active, while running under command of the remote start. If this wire is active

when the system is armed, the siren will emit three chirps. When the zone clears, the siren will emit 1 chirp

to confirm full arming.

NOTE: For vehicles with interior delay lighting see programming under title "Completing The Installation".

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Audiovox AFX-35.00 Installation Manual Page 10