128-8971a
8 of 32
8
WIRING CONNECTIONS: 16 Pin Accessory Input/Output Harness PART # 1124049
1 Dark Blue/Black Trace Wire: External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external source. The
intent of this wire is to allow the unit to be controlled from a "POSSE/CAR-LINK" paging system or similar
device. When this wire receives a ground pulse, the unit will start the vehicle. Connect this wire to a ground
pulsed output from the controlling circuit.
2 Grey Wire: Negative Inhibit Input / Trigger When Armed
The Grey wire provides an instant shutdown for the Remote Start Control Module whenever it is grounded.
This wire also trigger the alarm when armed. Connect the Grey wire to the hood pin switch previously
installed. This wire must be routed through a grommet in the firewall and connected to the hood pin switch.
If connecting to a factory hood pin switch, it is recommended that a double diode circuit be used to prevent
feed back of one device to the other.
IMPORTANT! This connection is a safety wire and must be connected as shown and tested as specified.
Failure to do so may result in personal injury or property damage. See detail of wiring in the following
diagram. This wire may also be used if the vehicle brake light circuit switches ground to the brake lights.
An isolation diode must be used for ground switched brake light circuits and must be connected to the
output of the brake switch.
3 Green/Yellow Wire: Diesel Wait To Start Input
The green/yellow wire, when connected to the wire that get + 12 Volts during the glow plug preheat stage
will delay the starter output until this wire drops the 12 Volts. In other words, in a Diesel vehicle with glow
plug preheat circuit, when the ignition is turned on, the vehicle will not crank until the glow plugs are hot
enough to fire the atomized fuel oil when injected into the cylinder. By connecting this wire to the glow plug
+ 12 Volt wire, when the remote start unit activates the ignition one output, the glow plug output also
activates. The remote start sees the green/yellow with positive voltage and waits for this to go inactive
(drop the 12 Volts) before activating the starter motor. If this wire is not used or you have difficulty access-
ing the glow plug preheat circuit, you may elect to utilize the Diesel timed output as specified in Remote
Start feature selection #9. NOTE: If green/yellow is used, it will override or negate any setting of feature #9.
4 White Wire: Parking Light Flasher Output
This wire is the normally open contact of the on board parking light flash relay. Connect this wire to the
vehicle's parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's
parking light switch is activated.
5 White w/ Red Trace Wire: Parking Light Flasher Input
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are working
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals