Audiovox AFX-35.00 Installation Manual download pdf (Page 24)

128-8971a

24 of 32

METHOD 2:

To connect to the key in sensor circuit as shown for method 2:

1. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.

2. Cut this wire and connect the ignition cylinder side to chassis ground.

3. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder .

4. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down

Wire Gray/Black, using a 4002 series diode as shown above.

NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut

down circuit. If this is the case, it must be installed as shown in the diagram above. The anode

(Non Striped) side must be connected to the Gray/Black wire of the Remote Start Unit. The

cathode (Striped) side must be connected to the hood pin switch. If the hood pin switch is also

used for an alarm trigger input, be certain to use the dual diode set up shown earlier in

this manual.

AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS

INDICATED IN ANY OF THE PREVIOUS ALTERNATE CONFIGURATIONS, THIS CIRCUIT

MUST BE TESTED FOR PROPER OPERATION.

Retest by following the steps outlined in the NEUTRAL START SAFETY TEST section of the manual.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Audiovox AFX-35.00 Installation Manual Page 24