Audiovox AFX-35.00 Installation Manual download pdf (Page 14)

128-8971a

14 of 32

Red w/Black Trace Wire : DISARM INPUT #2

Connect this wire to the unlock side of the door lock/unlock switch or any passenger door unlock motor wire,

which will receive a negative or positive pulse when all doors are unlocked using the door panel switch or the

remote transmitter, but will not receive a pulse when the driver only door is unlocked using the

remote transmitter.

NOTE: The Green/Black, Red, Green, & Red/Black wires MUST be connected to their respective source

before powering up the module as these wire are polarity learn and will not function properly if

connected after power up. In addition, these wires if not used as indicated above these must be

connected to ground. This will insure proper operation and prevent inadvertent arming and

disarming unintentionally.

Blue Wire : Trunk Trigger Shunt Input

This wire will determine if the vehicle’s trunk has been opened using the OEM transmitter, and prevent the

alarm from triggering when the factory transmitter is used. This wire requires a positive trigger input and must

be wired to the switched + 12 Volt trunk control wire from the vehicle's keyless entry unit or, the switched

+ 12 Volt side of the vehicle's trunk release solenoid.

WIRING THE ARM / DISARM INPUTS IN VEHICLES WHEN THE SYSTEM IS

SET UP AS A STAND ALONE PASSIVE (IGNITION CONTROL) ALARM SYSTEM

For this mode of operation, be certain to set selectable features # 6 for passive arm, feature #18 for trigger

delay.

Green/Black & Green Wire: Arm Inputs

Connect these wires to chassis ground.

Red Wire : Disarm Input #1

Connect this wire to an ignition source that has +12 Volts when the ignition switch is turned to the on and

start positions and has 0 Volts when the switch is in any other position.

Red w/Black Trace Wire: Disarm Input #2

Connect this wire to chassis ground.

Blue: Trunk Shunt Input

This wire is not used for the stand alone passive alarm application.

2 Pin Door Lock/Unlock Harness: (White Connector) 300mA Part # 1122242

1 Red Wire: (-) Lock or (+) Unlock

The Red wire provides a (-) Negative Pulse when locking and a (+) Positive Pulse when unlocking.

2 Green: (+) Lock or (-) Unlock

The Green wire provides a (+) Positive Pulse when locking and a (-) Negative Pulse when unlocking.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Audiovox AFX-35.00 Installation Manual Page 14