Audiovox AFX-35.00 Installation Manual download pdf (Page 28)

128-8971a

28 of 32

The transmitters are pre-programmed from the factory, If you find you need to program new or additional

transmitters follow the instructions below.

PROGRAMMING BANK 1 (TRANSMITTERS): When Using ADDP1 or ADDSS

1. Turn the ignition key to the on position.

2. Press and release the valet/programming switch 3 times (Siren Chirps).

3. Press the Start Button of each transmitter you want programmed until you hear a chirp from the horn

or siren.

4. Turn the ignition switch off.

The above action programs Start function for the system. Test your system by pressing the start button of the

transmitter two times in succession.

PROGRAMMING BANK 2 (ALARM FEATURES):

You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1.

(Siren Short then Long Chirp), or You can also go right to bank 2 by:

1. Turn the ignition key to the on position.

2. Press and release the valet/programming switch 3 times (Siren Chirps).

3. Turn the ignition key off then on. (Siren Short Then long Chirp)

4. Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc, then use the

lock button of the transmitter to select the feature setting.

Example to set passive arming:

1. Turn the ignition key to the on position.

2. Press and release the valet/programming switch 3 times (Siren Chirps).

3. Turn the ignition key off then on. (Siren Short Then long Chirp)

4. Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button of

the transmitter to select two chirps "Passive Arm".

5. To exit the programming mode, turn the ignition key off. The program mode is automatically exited when

there is no activity on the pushbutton switch or the transmitter lock button.

1 2 ... 23 24 25 26 27 28 29 30 31 32

No comments

Audiovox AFX-35.00 Installation Manual Page 28