Audiovox CTV-5060 Service Manual download pdf (Page 106)

106

Trouble Shooting Guide

Graphics

General Information

General Requirements

* IMPORTANT:

The following information should be carefully reviewed before proceeding:

Tools

• Plastic Applicator, PA-1 (Blue or Gold)*

• Masking Tape

• Felt Block Applicator**

• Low Friction Sleeve, SA-1*

• (For certain applications, such as unpremashed screen-printed Graphics, use a low

friction sleeve on the plastic applicator to minimize the possibility of surface

scratching).

• Pin or air release tool*

• Razor blades

• Industrial heat gun

• Detergent and water solution (1% or 1/2 teaspoon per quart of water)

Solvents

• DuPont’s Prep-Sol Brand Solvent Cleaner

• Isopropyl Alcohol

• VMP Naphtha

* Available from 3M

** Available from local craft store

Application Temperature

The graphics tape can be applied when air and application surface temperatures are

between 65 degrees and 90 degrees. Surfaces may be heated in order to raise the

surface temperature. Portable heater, heat lamps, or hot water may accomplish this.

Surface Preparation

All surfaces must be considered contaminated and must be cleaned prior to application

of film or fabricated parts. On repainted vehicles, paint must be thoroughly dry before

any attempt to apply decals to the vehicle is made. 48 hours after painting is recom-

mended.

The recommended procedure is as follows:

1. Wash the surface with detergent and water before solvent wiping.

2. Dampen a clean cloth with Isopropyl alcohol or DuPont Prep-Sol Brand Solvent

Cleaner #3919S and wipe the substrate surface.

3. Dry the surface with lint-free cloth before the solvent evaporates.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 323 324

No comments

Audiovox CTV-5060 Service Manual Page 106