Audiovox CTV-5060 Service Manual download pdf (Page 29)

Door Panel, Cargo Door, Side (Front)

1. Remove caps from pull handle by unsnapping.

2. Remove exposed screws, remove handle.

3. Remove screws from molded mag rack/ cup holder, if equipped.

4. Remove fold down cup holder screws, if equipped.

5. Remove factory door handle bezel.

6. Grasp edge of door panel at top and pull outward until retainers are free. Continue

this motion all around panel to complete process.

Door Panel, Cargo Door, Side (Rear)

1. Remove caps from pull handle by unsnapping.

2. Remove 4 exposed screws, remove handle.

3. Grasp edge of door panel at top and pull outward until retainers are free. Continue

this motion all around panel to complete process.

Head Board

1. Remove map light cover and unscrew housing. Remove map lights.

2. Unsnap faceplate switch cover, this exposes 4 screws, and remove. Pull straight

back on switch plate and disconnect 3 plug in connectors, if equipped.

3. Remove headboard wood trim piece.

4. Reach through hole where switch assembly was, grasp and pull straight back until

headboard clips are free from factory lip in roof.

5. Tilt rear of headboard down and pull rearward until free.

Headliner

1. Remove map light covers and unscrew housing. Remove lights from center beam.

2. Remove center beam per procedures.

3. Remove rear map light covers and unscrew housings located in headliner. Remove

lights from center beam.

4. Remove valances per procedures.

5. Remove headboard (refer to procedure).

6. Remove screws from headliner, located where center beam was.

7. Slide forward until rear cleats release from factory roof lip.

8. Remove headliner.

Panel, Speaker, Rear

1. Remove rear storage cabinets in passenger sidewall, if equipped.

2. Using razor knife cut fabric along door edge, pull fabric loose to expose screws.

3. Remove screws.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 323 324

No comments

Audiovox CTV-5060 Service Manual Page 29